HP CM3530 Service Manual - Page 494

Table 7-12 Control-panel messages (continued) Control panel message Description Recommended action Replace Supplies - Using black A color supply (or supplies) has reached the No user input is required for printing to out condition and the Color Supply Out menu continue. Printing continues in black. item is set to Autocontinue black. Replace transfer kit The supply has reached the end of life. Printing can continue. Replace transfer kit. See Intermediate transfer belt (ITB) on page 209. Replace transfer kit To continue, touch OK The transfer kit is at the end of life. Printing can continue, but print quality might be reduced. The product is set to stop printing when a supply needs to be ordered. To continue printing, touch OK. Replace the ITB. See Intermediate transfer belt (ITB) on page 209. Request Accepted Please Wait This message appears when a request to Wait for the internal page to print. print an internal page is accepted but cannot print. Resend external accessory firmware An external accessory requires a firmware Perform a firmware upgrade. upgrade. Printing can continue, but jams may occur if the job uses the external accessory. Resend upgrade A firmware upgrade did not complete successfully. Upgrade the firmware again. Restoring factory settings A Restore Factory Settings reset is being performed. No action is necessary. Restoring... A Restore Last Saved State, Restore Print Modes, Restore Optimization, or Restore Color Values operation is being performed. No action is necessary. Restricted from printing in color The print job is being forced to print in black either because the product is set to print only in black or because the user ID and application ID do not have color printing permissions. No action is necessary. RFU LOAD ERROR A failure occurred during the remote firmware Resend the upgrade. upgrade. ROM Disk Device Failure - To Clear Touch The specified device failed. OK Touch OK to clear. ROM Disk file operation failed To clear touch OK A PJL file system command was received that attempted to perform an illogical operation, such as downloading a file to a non-existent directory. Touch OK to clear the message. ROM Disk is write protected To clear touch OK The device is protected and no new files can Touch OK to clear the message. be written to it. ROM Disk Not Initialized The file system device must be initialized before it can be used. Initialize the device. Rotating Motor A component test is in progress; the Press Stop to stop the test. component selected is the cartridge motor. Rotating Motor - To exit press STOP The product is executing a component test Press Stop to stop the test. and the component selected is a motor. Sanitizing Disk % Complete Do not power off The hard disk is being cleaned. Contact the network administrator. 464 Chapter 7 Solve problems ENWW