HP CM3530 Service Manual - Page 496

Table 7-12 Control-panel messages (continued) Control panel message Description Recommended action Unsupported data on [FS] DIMM in slot The data on the DIMM is not supported. The DIMM may need to be replaced. Turn off the product before removing it. To clear this warning, touch OK. Unsupported USB accessory detected The USB accessory is not recognized and cannot be used by this product. Remove the USB accessory. To clear this message, touch OK. Upgrade complete To continue, turn off Upgrade complete. and then on Turn the product off and then on. USB ACCESSORY UNAVAILABLE The USB accessory was installed after the 1. product was turned on. The product does not support plug-and-play operation. 2. Remove the USB accessory. Turn the product off, and then plug in the USB accessory. 3. Turn the product on. USB Device Failure - To Clear Touch OK The specified device failed. Touch OK to clear. USB file operation failed To clear touch OK A PJL file system command was received that attempted to perform an illogical operation, such as downloading a file to a non-existent directory. Touch OK to clear the message. USB HUBS NOT FULLY SUPPORTED Some USB hubs require more power than the 1. Remove the USB hub. product has available. USB is write protected To clear touch OK The device is protected and no new files can Touch OK to clear the message. be written to it. USB needs too much power Power requirements for the USB accessory attached to this product are beyond supported limits. Detach the accessory, and then turn the product off and then on. Try a similar accessory that has its own power supply or requires less power. USB Not Initialized The file system device must be initialized before it can be used. Initialize the device. USB storage is initializing The designated USB storage unit is initializing. No action is necessary. USB storage is not functional A parameter in the USB storage is not working correctly. Turn the product off. Disconnect the USB storage accessory, and replace with a new USB storage accessory. USB storage removed A USB storage accessory has been disconnected since the product was turned on. To continue using the USB accessory, turn the product off and reconnect it. Turn the product off and then on to clear the message. USED SUPPLY IN USE One or more used supplies have been installed. 1. Install new supplies. 2. If you believe you purchased a genuine HP supply, visit us at www.hp.com/go/ anticounterfeit. Any repair required as a result of using used cartridges is not covered under warranty. Supply status and features depending on supply status are not available. Wait for printer to reinitialize The user changed the RAMDISK settings. The product automatically restarts. No action is necessary. Waiting for tray to lift The tray number specified by is in the No action is necessary. process of lifting the paper to the top of the tray for proper feeding. 466 Chapter 7 Solve problems ENWW