HP CM3530 Service Manual - Page 489

Table 7-12 Control-panel messages (continued) Control panel message Description Recommended action and Reboot, but it does not restart the product. Image CRC error This message is displayed before the firmware is loaded at startup when an error occurs during a firmware upgrade. Resend the upgrade. Incompatible fuser The wrong fuser is installed. The product will Install the correct fuser. See Fuser not print, even though the fuser fits the on page 200. product. Incompatible supplies Two or more incompatible supplies are installed. The product will not print, even though the supplies fit the product. Install the correct supply. INFLATE FAILURE An error occurred during the firmware upgrade. Resend the upgrade. Initializing permanent storage Product is initializing permanent storage. No action is necessary. Initializing scanner The scanner is initializing. Wait until the scanner is Ready before proceeding to scan. Install cartridge The print cartridge has been removed or has Replace or reinstall the print cartridge been installed incorrectly. correctly to continue printing. Install fuser The fuser is either not installed or not installed Install the fuser. See Fuser on page 200. correctly. Install supplies At least two supplies are missing. Replace the missing supplies or make sure the installed supplies are fully seated. Install transfer unit The ITB is either not installed or not installed Replace the ITB. See Intermediate transfer correctly. belt (ITB) on page 209. Insufficient memory to load fonts/data To continue touch OK The product does not have enough memory Touch OK to continue without this to load the data (for example, fonts or information. If the message persists, add macros) from the location specified. memory. Internal Disk Device Failure - To Clear Touch OK The specified device failed. Touch OK to clear the message. Internal disk file operation failed To clear A PJL file system command attempted to Touch OK to clear. touch OK perform an illogical operation, such as downloading a file to a non-existent directory. Internal Disk Initializing The internal disk is initializing. No action is necessary. Internal disk is write protected To clear touch OK Internal disk not found Internal disk not functional Internal disk not initialized Internal disk spinning up The product is protected and no new files can Touch OK to clear the message. be written to it. Internal disk not found. Turn the product off and then on. The internal disk is not functional. Copy and send is disabled. Turn the product off and then on. The internal disk is not initialized. Initialize the disk. The internal disk is spinning up its platter. It usually shows for approximately 15 seconds when the product comes out of power-save mode. Jobs can still print, but jobs that require disk access (i.e., stored jobs) must wait. No action is necessary. ENWW Control-panel messages 459