HP CM3530 Service Manual - Page 500

Event log message 54.0F.XX 54.14 54.1E.XX 55.06.01 55.06.02 55.901C 61.00.01 67.XX.00 68 8X01 470 Chapter 7 Solve problems Description Comments ● XX=02: Magenta densitymeasurement abnormality ● XX=03: Yellow densitymeasurement abnormality 4. Touch Full Calibration. 5. Touch Calibrate. ● XX=00: Black misregistration is out 1. Scroll to and touch Administration. of range. 2. Scroll to and touch Print Quality. ● XX=01: Cyan misregistration is out of range. 3. Touch Calibration/Cleaning. ● XX=02: Magenta misregistration is 4. Touch Full Calibration. out of range. 5. Touch Calibrate. ● XX=03: Yellow misregistration is out of range. CPR sensor abnormality 1. Scroll to and touch Administration. 2. Scroll to and touch Print Quality. 3. Touch Calibration/Cleaning. 4. Touch Full Calibration. 5. Touch Calibrate. Halftone calibration error. 1. Scroll to and touch Administration. 2. Scroll to and touch Print Quality. 3. Touch Calibration/Cleaning. 4. Touch Full Calibration. 5. Touch Calibrate. The DC controller NVRM has an abnormal read/write. 1. Turn the product off then on. 2. If the error persists, replace the DC Controller. See DC controller PCA and tray on page 270. The DC controller NVRM is not accessible. 1. Turn the product off then on. 2. If the error persists, replace the DC Controller. See DC controller PCA and tray on page 270. DCC restored DCC NVRAM was restored from the formatter. Color table error This event occurs when the color table cannot read a table from the disk and the component reverts to the version in RAM. The file could be corrupt, missing, or the disk could have failed. No messages display on the control panel. A system variable (XX) is out of range. Permanent storage was reset to factory default because the current value was not valid. ENWW