HP CM3530 Service Manual - Page 70

Table 2-12 Fax Setup menu (continued) Menu item Sub-menu item Sub-menu item Redial Interval Detect Dial Tone Dialing Prefix Billing Codes Fax Receive Settings Rings To Answer Ring Interval Ring Frequency Ringer Volume Blocked Fax Numbers Add Blocked Numbers Remove Blocked Numbers Clear All Blocked Numbers Values Description The range is between 1 and 5 minutes. The factory default is 5 minutes. Use this feature to specify the number of minutes between dialing attempts if the recipient number is busy or not answering. Enabled Disabled (default) Use this feature to specify whether the product should check for a dial tone before sending a fax. Off (default) Custom Use this feature to specify a prefix number that must be dialed when sending faxes from the product. Off (default) Custom When billing codes are enabled, a prompt appears that asks the user to enter the billing code for an outgoing fax. The range is between 1 and 16 digits. The default is 1 digit. The range varies by Use this feature to specify the number of rings location. The factory that must occur before the fax modem default is 2 rings. answers. Default (default) Custom This setting is used to adjust for some PBX ring signals. Change this setting only when directed by an HP technical support agent. Default (default) Custom This setting should be left at the default value and only changed when directed by an HP technical support agent. Adjustment procedures associated with this setting are beyond the scope of this guide. Off Set the volume for the fax ring-tone. Low (default) High Type the fax number to add. Select a fax number to remove. No (default) Use this feature to add or delete numbers from the blocked fax list. The blocked fax list can contain up to 30 numbers. When the product receives a call from one of the blocked fax numbers, it deletes the incoming fax. It also logs the blocked fax in the activity log along with job-accounting information. Yes 40 Chapter 2 Control panel ENWW