HP Deskjet 6980 User Guide - Windows 2000 - Page 53
Connect the printer to an Ethernet network, State of the Link light
UPC - 882780129580
View all HP Deskjet 6980 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
First you must connect the printer to the network. Then you must install the printer software on each computer that will use the printer. ● Connect the printer to an Ethernet network ● Install the printer software Connect the printer to an Ethernet network Follow these steps to connect the printer to an Ethernet network: 1. If necessary, set up the printer hardware. For printer hardware setup instructions, see the setup poster that came with the printer. 2. Verify that the printer is powered on. 3. Connect the Ethernet cable to an available port on the network hub or router. Note Do not plug the Ethernet cable into a port labeled WAN, Uplink, or Internet. 4. Connect the Ethernet cable to the Ethernet port on the back of the printer. Note The printer's wireless radio is disabled when a Ethernet cable is connected to the printer. 5. Do one of the following: State of the Link light Task On Go to step 6. Off User's guide Repeat steps 2 through 4. If the lights are still off, verify the following items: - The printer is powered on. - The network hub or router is powered on. - All cable connections are secure. - You are using an Ethernet cable. 51