HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based - Page 117
Switch Management Processor Configuration buttons
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
The following table describes the Switch Management Processor Configuration (SNMP) controls: Table 91 Switch Management Processor Configuration (SNMP) controls Control Description SNMP System Name SNMP Location SNMP Contact SNMP Read Community String SNMP Write Community String SNMP state machine timeout (1-30 minutes) Send SNMP Auth. Failure Traps? Configures the name for the system. The name can have a maximum of 32 characters. Configures the name of the system location. The location can have a maximum of 32 characters. Configures the name of the system contact. The contact can have a maximum of 32 characters. Configures the SNMP read community string. The read community string controls SNMP "get" access to the switch. It can have a maximum of 32 characters. The default read community string is public. Configures the SNMP write community string. The write community string controls SNMP "set" and "get" access to the switch. It can have a maximum of 32 characters. The default write community string is private. Sets the timeout value for the SNMP state machine. Enables or disables the use of the system authentication trap facility. The default setting is disabled. Switch Management Processor Configuration buttons The following table describes the Switch Management Processor Configuration buttons: Table 92 Switch Management Processor Configuration buttons Control Description Submit Diff Diff Flash Revert Revert Apply Sends this form to the switch. Any configuration changes are placed in the "pending" state and do not take effect until the toolbar Apply command is given. Shows any pending configuration changes. Compares new configuration with the flash configuration. Removes pending configuration changes between apply commands. Use this command to restore configuration parameters set since last apply command. Removes pending configuration changes between save commands. Use this command to restore configuration parameters set since last save command. Configuring the switch 117