HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based - Page 152
LACP Port Configuration, Uplink Fast General Configuration, Layer 2 > UpLink Fast - manual
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
LACP Port Configuration To display the following form, go to the Switch LACP Configuration form. Select a port number. The following table describes the LACP Port Configuration controls: Table 120 LACP Port Configuration controls Control Port Admin Key Port Priority Port LACP Mode Description Set the admin key for this port. Only ports with the same admin key and oper key (operational state generated internally) can form a LACP trunk group. Sets the priority value for the selected port. Lower numbers provide higher priority. Default is 128. Set the LACP mode for this port, as follows: • off: Turn LACP off for this port. You can use this port to manually configure a static trunk. The default value is off. • active: Turn LACP on and set this port to active. Active ports initiate LACPDUs. • passive: Turn LACP on and set this port to passive. Passive ports do not initiate LACPDUs, but respond to LACPDUs from active ports. Uplink Fast General Configuration To display the following form, select Layer 2 > UpLink Fast. Configuring the switch 152