HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based - Page 173

The following table describes the IGMP Snooping Configuration controls: Table 141 IGMP Snooping Configuration controls Control Descriptions IGMP on? Enables or disables IGMP Snooping. Set report timeout Configures the timeout value for IGMP Membership Reports (host). Once the timeout value is reached, the switch removes the host from its IGMP table, if the conditions are met. The range is from 1 to 255 seconds. The default is 10 seconds. Set multicast router timeout Configures the timeout value for IGMP Membership Queries (Mrouter). Once the timeout value is reached, the switch removes the multicast router from its IGMP table, if the proper conditions are met. The range is from 1 to 255 seconds. The default is 255 seconds. Set robust value or expected packet loss on subnet Configures the IGMP Robustness variable, which allows you to tune the switch for expected packet loss on the subnet. If the subnet is expected to be lossy (high rate of packet loss), increase the value. The range is from 2 to 10. The default value is 2. Set query interval Sets the IGMP router query interval, in seconds. The default value is 125. Aggregate IGMP report Enables or disables IGMP Membership Report aggregation. Set Source IP for GSQ proxy Configures the source IP address used as a proxy for IGMP Group Specific Queries. Remove all VLANs from IGMP Snooping Removes all VLANs from the list of Snooping VLANs. Configured VLANs Lists the VLANs that can be assigned for IGMP Snooping. Snooping VLANs Enables or disables IGMP Snooping on selected VLANs. Add: Adds selected VLANs to the Snooping VLANs list. To add a VLAN, select the VLAN in the Configured VLANs list, and click Add. Remove: Removes selected VLANs from the Snooping VLANs list. Snooping VLANs without Fstleave Lists the Snooping VLANs that can be assigned for Fstleave processing. Snooping VLANs with Fstleave Enables or disables FastLeave processing. FastLeave allows the switch to immediately remove a port from the IGMP port list, if the host sends a Leave message, and the proper conditions are met. This command is disabled by default. Add: Adds selected VLANs to the Snooping VLANs with Fstleave list. To add a VLAN, select the VLAN in the Snooping VLANs without Fstleave list, and click Add. Remove: Removes selected VLANs from the Snooping VLANs with Fstleave list. IGMP Filters Configuration To display the following form, select Layer 3 > IGMP > IGMP Filters (click the underlined text, not the folder). This form summarizes IGMP filter parameters. Use IGMP filters to allow or deny a port to send and receive multicast traffic. Configuring the switch 173