HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based - Page 128

Table 98 Switch Image and Configuration Management controls Control Image Filename (on server) Image Filename (on HTTP Client) Config/Dump Settings Configuration Filename TS Dump Filename Flash Dump Filename Status of Previous Transfer Description Enter the name of the file on a TFTP server that contains the software image you want to download. Enter the name of the file on an HTTP Client that contains the software image you want to download. Selects the file name and location of the Configuration Block file to be downloaded. Selects the filename for the TS (tech support) dump that you want to upload to the TFTP server. Selects the filename for the core (PANIC) dump that you want to upload to the TFTP server. Displays the status of the previous software download attempt. Switch Image and Configuration Management buttons The following table describes Switch Image and Configuration Management buttons: Table 99 Switch Image and Configuration Management buttons Button Description Get Image Put Image Get Config Put Config Put TS Dump Put Dump Clear Flash Dump Submit REBOOT! Starts download of the software image file indicated in TFTP Image Filename field from the specified TFTP server. Starts upload of the software image file indicated in TFTP Image Filename field from the specified TFTP server. Downloads a previously saved switch Configuration Block file indicated in Configuration Filename from the specified the TFTP server. The active configuration will be replaced with the commands found in the downloaded configuration file. The file can contain a full switch configuration or a partial switch configuration. The new configuration is not activated until the apply command is used. If the apply command is found in the configuration script file loaded using this command, the apply action is performed automatically. Uploads the switch's active configuration to the script configuration file specified in Configuration Filename. The file is placed on the TFTP server. Uploads the TS (tech support) dump file to the TFTP server specified in TSTP TS Dump Filename. Uploads the core (PANIC) dump file to the TFTP server specified in Core Dump Filename. Deletes the core dump in flash memory. When selected, the form is sent to the switch. Any configuration changes are placed in the "pending" state and do not take effect until the toolbar Apply command is given. Reboots the switch. NOTE: If the TFTP server is running SunOS or the Solaris operating system, the specified Put Config file must exist prior to executing the Put Config command and must be writable (set with proper permission, and not locked by any application). The contents of the specified file will be replaced with the current configuration data. Configuring the switch 128