HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based - Page 184
OSPF Hosts Configuration, OSPF Virtual Link Configuration controls
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
The following table describes the OSPF Virtual Link Configuration controls: Table 151 OSPF Virtual Link Configuration controls Control Descriptions Virtual Link Identifier (1-3) Area Number (0-2) Enabled? Hello Interval (1-65535 sec) Dead Interval (1-65535 sec) Transmit Delay (1-3600 sec) Retransmit Interval (1-3600 sec) Virtual Neighbor Router ID Authentication Key MD5 Key ID (0-255) Assigns a numeric identifier to the virtual link. Defines the area index used by the virtual link. Enables or disables the OSPF virtual link. Displays the authentication parameters of a hello packet, which is set to be in an interval of seconds. Displays the health parameters of a hello packet, which is set to be in an interval of seconds. Default is 40 seconds. Displays the delay in transit in seconds. Default is one second. Displays the retransmit interval in seconds. Default is five seconds. Displays the router ID of the virtual neighbor. Default is 0.0.0.0 Displays the password (up to eight characters) for each virtual link. Default is none. Sets MD5 key ID for each virtual link. Default is 0 (none). OSPF Hosts Configuration NOTE: This form is available only on the GbE2c Layer 2/3 Ethernet Blade Switch. To display the following form, select Layer 3 > OSPF Routing Protocol > OSPF Hosts (click the underlined text, not the folder). Configuring the switch 184