HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Browser-based - Page 203
Access Control List Configuration controls, Table 170
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Table 170 Access Control List Configuration controls Control Ethernet Type VLAN ID (1-4095) 802.1p Priority Type of Service (0-255) Protocol (0-255) Source IP Address Destination IP Address TCP/UDP Src Port (1-65535) TCP/UDP Dst Port (1-65535) TCP Flags Statistics Egress Port Description Defines the Ethernet type for this ACL. Defines a VLAN number and mask for this ACL. Defines the 802.1p priority for the ACL. Defines a Type of Service value for the ACL. For more information on ToS, see RFC 1340 and 1349. Defines an IP protocol for the ACL. If defined, traffic from the specified protocol matches this filter. Specify the protocol number. Listed below are some of the well-known protocols. Number Name 1 icmp 2 igmp 6 tcp 17 udp 89 ospf 112 vrrp Defines a source IP address for the ACL. If defined, traffic with this source IP address will match this ACL. Specify an IP address in dotted decimal notation. Defines a destination IP address for the ACL. If defined, traffic with this destination IP address will match this ACL. Defines a source port for the ACL. If defined, traffic with the specified TCP or UDP source port will match this ACL. Specify the port number. Listed below are some of the well-known ports: Number Name 20 ftp-data 21 ftp 22 ssh 23 telnet 25 smtp 37 time 42 name 43 whois 53 domain 69 tftp 70 gopher 79 finger 80 http Defines a destination port for the ACL. If defined, traffic with the specified TCP or UDP destination port will match this ACL. Specify the port number, just as with sport above. Defines a TCP/UDP flag for the ACL. Enables or disables the statistics collection for the ACL. Selects an egress port to add to the ACL. The egress port ACL will not match a Layer 2 broadcast or multicast packet. The egress port ACL will not match packets if the destination port is a trunk. Configuring the switch 203