HP OmniBook 6100 HP Omnibook 6100 - Corporate Evaluators Guide - Page 207

Reference Information Modem Reference Information Command S$ Sr=n Sr? V0 V1 X0 X1 X2 X3 X4 Y0 Y1 Y2 Y3 Y4 Z0 Z1 Z2 Z3 Z4 Z5 $ &$ &A0 &A1 &A2 &A3 &B0 &B1 &B2 &C0 &C1 &D0 &D1 &D2 &D3 &F0 &F1 &F2 &G0 &G1 &G2 &H0 Function (3Com/US Robotics) Display the list of S-register settings Set S-Register "r" to "n" Display the value of S-Register "r" Display result codes in numeric form Display result codes in verbose form (words) Report basic call progress result codes, i.e., OK, CONNECT, RING, NO CARRIER, (also, for busy, if enabled, and dial tone not detected), NO ANSWER and ERROR Report basic call progress result codes and the connect rates-OK, CONNECT, RING, NO CARRIER (also, for busy, if enabled, and dial tone not detected), NO ANSWER, CONNECT XXXX and ERROR Report basic call progress result codes and the connect rates i.e., OK, CONNECT, RING, NO CARRIER (also, for busy, if enabled), NO DIAL TONE, NO ANSWER, CONNECT XXXX and ERROR Report basic call progress result codes and connection rate i.e., OK, CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY and ERROR Report all call progress result codes and connection rate i.e., OK, CONNECT, RING, NO CARRIER, NO ANSWER, CONNECT XXXX, BUSY, NO DIAL TONE and ERROR On the next reset, use &W0 settings On the next reset, use &W1 settings On the next reset use, &F0 settings On the next reset, use &F1 settings On the next reset, use &F2 settings Reset the modem according to the settings of ATY Reset the modem and use &W0 settings Reset the modem and use &W1 settings Reset the modem using &F0 settings and load factory default profile 1 Reset the modem using &F1 settings and load factory default profile 0 Reset the modem using &F2 settings and load factory default profile 2 Display the list of AT commands Display the list of ampersand commands Disable data compression result codes Enable data compression result codes Enable modulation result codes Enable data compression result codes and add V.42bis and MNP 5 protocol indicators Use a floating DTE speed Use a fixed DTE speed Use a fixed DTE speed when using data compression Carrier detect is always on Carrier detect is controlled by the modem. Ignore DTR Use online command mode DTE controls DTR DTE controls DTR and reset Set the factory profile that uses hardware (RTS/CTS) flow control (this is the active profile when the modem is shipped) Set the factory profile that uses hardware (RTS/CTS) flow control Set the factory profile that uses software (XON/XOFF) flow control No guard tone Use 550 Hz guard tone Use 1800 Hz guard tone Flow control for transmitted data - Disable flow control Corporate Evaluator's Guide 207