HP OmniBook xe3-gc HP OmniBook XE3 Series - Corporate Evaluator's Guide - Page 71
To connect to the port replicator, To disconnect from the port replicator
View all HP OmniBook xe3-gc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Making Connections Connecting External Components To connect to the port replicator 1. Plug in the AC adapter, then connect it to the rear of the port replicator. Make sure that the AC status light is on. 2. Align the computer with the locator pins on the port replicator. 3. Press the computer down until it clicks into place. Make sure that the dock status light is on. 4. Open the computer and slide the power switch to the left to turn it on. After the computer is turned on, you can close the lid while it is running. To disconnect from the port replicator 1. Press down on the release tab on the right side of the port replicator. Corporate Evaluator's Guide 71
Making Connections
Connecting External Components
Corporate Evaluator’s Guide
71
To connect to the port replicator
1.
Plug in the AC adapter, then connect it to the rear of the port replicator. Make sure
that the AC status light is on.
2.
Align the computer with the locator pins on the port replicator.
3.
Press the computer down until it clicks into place. Make sure that the dock status light
is on.
4.
Open the computer and slide the power switch to the left to turn it on.
After the computer is turned on, you can close the lid while it is running.
To disconnect from the port replicator
1.
Press down on the release tab on the right side of the port replicator.