HP Pro 4300 Maintenance & Service Guide HP Compaq Pro 4300 All-in-One Busi - Page 52
Type 2,
View all HP Pro 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Type 2 a. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1). b. To insert the new battery, slide one edge of the replacement battery under the holder's lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2). Figure 6-26 Removing and replacing a coin cell battery (Type 2) Type 3 a. Pull back on the clip (1) that is holding the battery in place, and remove the battery (2). b. Insert the new battery and position the clip back into place. Figure 6-27 Removing a coin cell battery (Type 3) 44 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Type 2
a.
To release the battery from its holder, squeeze the metal clamp that extends above one
edge of the battery. When the battery pops up, lift it out (1).
b.
To insert the new battery, slide one edge of the replacement battery under the holder’s lip
with the positive side up. Push the other edge down until the clamp snaps over the other
edge of the battery (2).
Figure 6-26
Removing and replacing a coin cell battery (Type 2)
Type 3
a.
Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.
Insert the new battery and position the clip back into place.
Figure 6-27
Removing a coin cell battery (Type 3)
44
Chapter 6
Removal and Replacement Procedures All-in One (AIO) Chassis