HP Pro 4300 Maintenance & Service Guide HP Compaq Pro 4300 All-in-One Busi - Page 71
Memory Access Panel
View all HP Pro 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
To remove the system board shield: 1. Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 26). 2. Remove the center access panel (see Hinge Cover Panel on page 27). 3. Remove the memory access panel (see Memory Access Panel on page 29). 4. Remove the drive access panel (see Drive Access Panel on page 31). 5. Remove the stand (see Stand on page 54). 6. Remove the optical drive (see Optical Drive on page 33). 7. Remove the top panel (see Top Panel on page 51). 8. Remove the heat sink cover (see Heat Sink Cover on page 45). 9. Remove the rear cover (see Rear Cover on page 55). 10. Remove the two black Torx screws (1) that secure the shield to the computer. NOTE: The Torx screw in the lower left also secures the stand bracket. 11. Remove the two silver hex screws around the serial port (2). 12. Lift the shield from the computer. Figure 6-53 Removing the system board shield To install the system board shield, reverse the removal procedures. System Board Shield 63