HP Pro 4300 Maintenance & Service Guide HP Compaq Pro 4300 All-in-One Busi - Page 68
Sidekey Board
View all HP Pro 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Sidekey Board The sidekey board is located on the bottom left side of the computer (viewed from behind) under the main rear cover. It is secured with two Torx screws and has one connector. The associated cable connects to the front power switch assembly. To remove this cable, you must remove the stand bracket, disassembly of which is shown later in this document at Stand bracket on page 68. Figure 6-48 Sidekey board location To remove the sidekey board: 1. Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 26). 2. Remove the center access panel (see Hinge Cover Panel on page 27). 3. Remove the memory access panel (see Memory Access Panel on page 29). 4. Remove the drive access panel (see Drive Access Panel on page 31). 5. Remove the stand (see Stand on page 54). 6. Remove the optical drive (see Optical Drive on page 33). 7. Remove the top panel (see Top Panel on page 51). 8. Remove the rear cover (see Rear Cover on page 55). 60 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis