HP Pro 4300 Maintenance & Service Guide HP Compaq Pro 4300 All-in-One Busi - Page 76
Stand bracket
View all HP Pro 4300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Stand bracket The stand bracket is located near the middle of the computer, below the fan. Remove the bracket to gain access to the drive cables and sidekey board cable assembly. The bracket is secured with four Torx screws. Figure 6-59 Stand bracket location To remove the stand bracket: 1. Prepare the computer for disassembly (see Preparing to Disassemble the Computer on page 26). 2. Remove the center access panel (see Hinge Cover Panel on page 27). 3. Remove the memory access panel (see Memory Access Panel on page 29). 4. Remove the drive access panel (see Drive Access Panel on page 31). 5. Remove the stand (see Stand on page 54). 6. Remove the optical drive (see Optical Drive on page 33). 7. Remove the top panel (see Top Panel on page 51). 8. Remove the rear cover (see Rear Cover on page 55). 68 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis