HP StorageWorks 2/128 HP StorageWorks SAN Director 2/128 Installation Guide, V - Page 115
Removing a Filler Panel, Remove the two captive screws.
![]() |
View all HP StorageWorks 2/128 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Installing SAN Director 2/128 FRUs Note: If you inadvertently relatch the ejectors prior to the 16-port card being removed, wait at least one second prior to unlatching the ejectors again. 7. If the card is not being replaced by another 16-port card, install a filler panel to ensure correct cooling of the chassis and protection from dust. Removing a Filler Panel To remove a filler panel, follow these steps (see Figure 23): 1. Remove the two captive screws. 2. Grasp the handle in the middle of the faceplate. 3. Slide the filler panel out of the chassis. SAN Director 2/128 Installation Guide 115
![](/manual_guide/products/hewlettpackard-storageworks-2128-hp-storageworks-san-director-2128-installation-guide-v42x-aarvusbte-2004-deadb4a/115.png)
Installing SAN Director 2/128 FRUs
115
SAN Director 2/128 Installation Guide
Note:
If you inadvertently relatch the ejectors prior to the 16-port card being removed,
wait at least one second prior to unlatching the ejectors again.
7.
If the card is not being replaced by another 16-port card, install a filler panel
to ensure correct cooling of the chassis and protection from dust.
Removing a Filler Panel
To remove a filler panel, follow these steps (see
Figure 23
):
1.
Remove the two captive screws.
2.
Grasp the handle in the middle of the faceplate.
3.
Slide the filler panel out of the chassis.