HP StorageWorks 2/128 HP StorageWorks SAN Director 2/128 Installation Guide, V - Page 61
Enter, Ctrl-C, or enter
![]() |
View all HP StorageWorks 2/128 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Installing and Configuring the SAN Director 2/128 6. When the terminal emulator application stops reporting information, press Enter. 7. Log in to the switch as admin. The default password is password. Note: At the initial login, the user is prompted to enter new admin and user passwords. 8. Modify passwords, if desired. Passwords can be 8 to 40 characters long and should include a combination of numbers and upper/lowercase letters. To skip modifying the password, press Ctrl-C. Example: Fabric OS (swDir) swDir login: admin Password: Please change your passwords now. Use Control-C to exit or press 'Enter' key to proceed. Password was not changed. Will prompt again at next login until password is changed. swDir:admin> 9. Check the "Active CP" LED on the CP cards in slots 5 and 6 (see Figure 11), or enter the hashow command to verify which CP card is active. The configuration can be modified only through a login session to the active CP card. Example: swDir: admin> haShow Local CP (Slot 6, CP1): Active Remote CP (Slot 5, CP0): Standby HA Enabled, Heartbeat Up, State Synchronized SAN Director 2/128 Installation Guide 61
![](/manual_guide/products/hewlettpackard-storageworks-2128-hp-storageworks-san-director-2128-installation-guide-v42x-aarvusbte-2004-deadb4a/61.png)