HP Surestore Tape Library Model 6/140 HP SureStore E Tape Library Model 6/140 - Page 192
Addressing, Device Addresses on a Fibre Channel Loop, Address Assignments, Address Conflicts
View all HP Surestore Tape Library Model 6/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
Introduction to Fibre Channel Fibre Channel Technology Addressing Device Addresses on a Fibre Channel Loop Each device on a Fibre Channel Arbitrated Loop (FC-AL) has a unique address known as the Arbitrated Loop Physical Address (AL_PA). There are 126 valid AL_PAs that correspond to the 127 devices allowed on a Fibre Channel loop with values between 0-255 (not all values are valid). The "address index" also represents the device's address. Address indexes are used on devices where external switch settings determine the AL_PA. Each number between 0-126 corresponds to one physical address. Address Assignments Soft addressing and hard addressing are used to assign a unique AL_PA to each device. A device using soft addressing will take the first available AL_PA as its own. If the device is later power-cycled, it might select a different AL_PA. Although soft addressing has an easy loop setup, many host systems (including HP-UX™ and Windows NT™) lack the ability to track such dynamic address changes. Hard addressing solves the problem of dynamically changing AL_PAs, but requires more user intervention to set up. The user must select an AL_PA for each device. When the device is connected to a loop, the device will attempt to use the user-specified AL_PA. If the device is later power-cycled, it will attempt to use the same AL_PA. This results in more stable addressing over time. Address Conflicts When all devices use soft addressing, address conflicts will not occur. However, if more than 127 devices are connected to the same loop, those extra devices will fall into a non-participating state in which they cannot communicate without reconfiguring the loop. When using hard addressing, address conflicts may occur if more than one device is trying to use the same AL_PA. When this occurs, one device will take the specified AL_PA. The other will either take the first available AL_PA or fall into a non-participating state, depending on the hardware. C- 8 Appendix C