HP Surestore Tape Library Model 6/140 HP SureStore E Tape Library Model 6/140 - Page 40

Getting Started Configuring the Host System Class I bc 0 bc 1 ba 0 ext_bus 1 target 3 autoch 2 target 4 tape 2 target 5 tape 4 If these drivers are already installed into the kernel, upon system boot they will automatically be associated with the hardware that they control. However, if drivers are missing, they must be installed. For more information on installing Fibre Channel drivers, refer to the HP Fibre Channel Mass Storage Adapter Service and User Manual (A3636-90002). A pass-through driver is used to manage the robotics controller. Since this driver is not dedicated for this particular device, it must be manually installed. The following sections describe this process: • Installing the pass-through driver (below) • Creating a device file for the robotics controller (page 1-25) • Verifying the installation (page 1-27) Installing the Pass-Through Driver Obtain information about the peripherals attached to the system: ioscan -f The screen should look similar to the following: H/W Path 8 Driver root bc S/W State CLAIMED CLAIMED 8/0 GSCtoPCI CLAIMED 8/0/2/0 8/0/2/0.0 8/0/2/0.0.0 8/0/2/0.1 8/0/2/0.1.0 8/0/2/0.2 8/0/2/0.2.0 c720 tgt schgr tgt stape tgt stape CLAIMED CLAIMED CLAIMED CLAIMED CLAIMED CLAIMED CLAIMED H/W Type BUS_NEXUS BUS_NEXUS BUS_NEXUS INTERFACE DEVICE DEVICE DEVICE DEVICE DEVICE DEVICE Description Pseudo Bus Converter PCI Bus Bridge GSCtoPCI Ultra Wide SCSI HP C7200-8000 QUANTUM DLT8000 QUANTUM DLT8000 1-24 Chapter 1