HP Surestore Tape Library Model 6/140 HP SureStore E Tape Library Model 6/140 - Page 52
Administration, Run Test, Lock Transport, If your computer is
View all HP Surestore Tape Library Model 6/140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
CAUTION NOTE Getting Started Moving or Shipping the Library b. Pull the unlocked door(s) out to access magazines and tapes. The door may also be key locked. Unlock the door if needed. c. Remove the magazine by lifting it straight up with the handle. d. To remove a tape, set the magazine on its back and grasp the top and bottom corners of the tape. Pull the tape straight out of the magazine and return the magazine to the library. 4. If shipping the library, lock the transport: a. From the Administration menu, select the Run Test menu. b. From Run Test, use the [-] or [+] keys to select Lock Transport. c. Select [OK]. d. Select [Run]. The front panel display will indicate that the transport has been locked. Do not power off the library until the interface is inactive. Removing power from a SCSI or Fibre Channel peripheral when the bus is active can result in data loss and/or indeterminate bus states. If your computer is connected to a LAN, be sure to check with your system administrator before powering off the library. 5. Power off the library. The power "standby" switch is recessed to avoid accidental power cycles. 6. To ship the library, remove all external cables and terminators. For an internal move, only disconnect the power cable, SCSI cables, the RMC ethernet cable, and the Fibre Channel connection from the host, hub, or switch. You do not need to remove the SCSI cables that connect the controller or the Fibre Channel interface to the drive modules, unless the library is being shipped. 1-36 Chapter 1