HP Surestore Tape Library Model 6/140 HP SureStore E Tape Library Model 6/140 - Page 95

Library Administration NOTE NOTE Library Administration Setting SCSI IDs 1. Enter the SCSI IDs menu. A message warns you that devices with the same SCSI ID must be connected to different SCSI buses. Select [OK]. 2. The Configure SCSI ID screen displays a message that indicates the drive position selected. Use the [-] or [+] key to select the drive or library controller, then select [OK]. Refer to "Library Back Panel" on page 1-12 or the product information labels located on the fifth level on the back of the library for the library's drive numbering arrangement. 3. The next screen displays the drive number and the current SCSI ID. Use the [-] or [+] key to select the desired SCSI ID, then select [OK]. 4. A confirmation screen will indicate either a successful or failed operation. If the SCSI ID assignment failed, the screen will indicate the reason, and then return to the Configure SCSI ID screen. After changing SCSI IDs, you can save the new settings to flash ROM by power cycling the library, which allows the settings to be recovered if the library is powered off for more than eight days. If this step is not completed and the library is powered off for more than eight days, the new settings may be lost. You can also set SCSI IDs from remote access. See "Using the Remote Management Card" on page 3-9. Chapter 3 3-21