IBM 8872 Service Guide - Page 132
Installation
UPC - 000435813060
View all IBM 8872 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
DCAC 1. Read the safety information that begins on page vii and "Installation guidelines" on page 99. 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables necessary to replace the device. 3. Remove the top cover (see "Top cover and bezel" on page 113). 4. Open the release latches on both ends of the I/O board and pull the board from the server slightly. 5. Note where each cable is connected, and then disconnect all cables from the I/O board and remove the assembly from the server. 6. If you are instructed to return the I/O board, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you. To install the replacement I/O board, complete the following steps: 1. Connect all cables to the internal connectors on the I/O board. 2. Align the board with the card guides and insert the board in the connector. 3. Close the release latches to seat the board in the connector. 4. Install the top cover (see "Top cover and bezel" on page 113). 5. Slide the server into the rack. 6. Connect the cables and power cords (see "Completing the installation" in the Installation Guide or User's Guide for cabling instructions). 7. Turn on all attached devices and the server. 116 IBM xSeries 460 Type 8872 and xSeries MXE 460 Type 8874: Problem Determination and Service Guide