Icom IC-R8600 Instruction Manual - Page 57

SCANS 9 Programmed scan and Fine Programmed scan Programmed scan and Fine Programmed scan (Example) P00A/00B P00A 144 MHz Scan P00B 148 MHz Lower edge Jump Upper edge Repeatedly scans between two Scan Edge frequencies (P00A/P00B ~ P49A/P49B). 1 LTo change the Scan Edge Memory channels, see "Writing a memory channel" for details. (p. 8-2) 2 LIf the both Scan Edges are the same frequencies, the Programmed scan does not start. LIn the Fine Programmed scan, the scan speed 3 decreases when the squelch opens, but the receiver keeps scanning. The scan tuning step 4 changes to 10 Hz when the squelch opens. 5 6 DDProgrammed scan operation 1. Open the SCAN screen. MENU » SCAN 2. Touch [TYPE/SET]. 3. Touch [PROG]. DDFine Programmed scan operation 7 1. Start a Programmed scan. LSee steps 1 ~ 6 in "Programmed scan operation" to 8 the left for details. 2. While Programmed scanning, touch [FINE]. LEach touch toggles the Programmed scan and the 9 Fine Programmed scan. While Programmed scanning 10 11 Blinks 12 13 4. Touch [SELECT] to select the item* to change, *Scan edge channel number (Example: P00A/P00B), scan edges (lower and upper frequencies), receive mode, filter and tuning step (TS). 14 15 16 17 5. Rotate , or to touch [EDIT] to change the setting. LThe changed settings are stored in the Program Scan Blinks 18 Edge channel. 6. T ouch [SELECT] several times to exit the edit mode, 19 then touch [START] or hold down ••The Programmed scan starts. for 1 second. While Fine Programmed scanning 20 LTo cancel the scan, touch [STOP] or push . Blinks 3. To close the SCAN screen, push EXIT . 21 Jumps to the lower edge Recalls the VFO frequency before the scan starts LTouch [STOP] or push to cancel the scan. 7. To close the SCAN screen, push EXIT . 9-4