Icom IC-R8600 Instruction Manual - Page 78
MAINTENANCE, Cleaning, Replacing fuse, DC power cable fuses, Circuitry fuse
View all Icom IC-R8600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
12 MAINTENANCE Cleaning D O NOT use harsh solvents such as benzine or alcohol when cleaning, because they will damage the receiver surfaces. If the receiver becomes dusty or dirty, wipe it clean with a dry, soft cloth. Replacing fuse If a fuse blows, or the receiver stops functioning, find and repair the cause of the problem. Then replace the damaged fuse with a new, adequately rated fuse. The fuses are installed in the DC power cable and the circuitry in the body, to protect the receiver. ••DC power cable fuses 3 A/125 V ••Circuitry fuse APS 3 A/58 V RWARNING! ••Disconnect the DC power cable from the receiver before replacing the fuse. ••NEVER use fuses that are not specified. CAUTION: When you remove a fuse, use longnose pliers to protect your fingers and the fuse holders. DDDC power cable fuses See the following illustration to replace the blown DC power cable fuse. DDCircuitry fuse 1. Remove the 10 screws, then remove the cover. 3 A/125 V fuses Fuse Coding explanation Fuse Coding: FUSE 125 V 3 A Fuse Voltage Rating: 125 Volts Fuse Current Rating: 3 Amperes 2. Replace the circuitry fuse as shown below. APS 3 A/58 V fuse 3. Replace the cover and the screws. 12-1