Icom IC-R8600 Instruction Manual - Page 58

9 SCANS ∂F scan ∂F scan and Fine ∂F scan (Example) Span: 100 kHz 93.2 MHz 93.3 MHz 93.4 MHz 100 kHz 100 kHz Start Jump Lower edge Center frequency Upper edge DD∂F scan operation 1. Select the VFO or Memory mode, then set the center frequency of the scan. 2. Open the SCAN screen. MENU » SCAN 3. Touch [TYPE/SET]. SCAN screen 4. Touch [∂F]. Repeatedly scans within the ∂F span area. The scan starts from the center frequency of VFO or selected memory channel. LIn fine ∂F scan, the scan speed decreases when the squelch opens, but the receiver keeps scanning. The scan tuning step changes to 10 Hz when the squelch opens. DDFine ∂F scan operation 1. Start the ∂F scan. LSee steps 1 ~ 6 in "∂F scan operation" to the left for details. 2. While ∂F scanning, touch [FINE]. ••Each touch toggles the ∂F scan and the Fine ∂F scan. While ∂F scanning Blinks 5. Touch [SELECT] to select the item, then rotate to change the setting. ••Set the center frequency and span. Blinks LThe scan does not start when the tuning step is wider than the span. 6. Touch [SELECT] several times to exit the edit mode, then touch [START] or hold down for 1 second. to start the ∂F scan. While Fine ∂F scanning LTo cancel the scan, touch [STOP] or push . 3. To close the SCAN screen, push EXIT . Blinks Jumps to the lower edge Recalls the VFO frequency before the scan starts LTo cancel the scan, touch [STOP] or push . 7. To close the SCAN screen, push EXIT . 9-5