Icom IC-V8000 Instruction Manual - Page 33
Reversed duplex mode - tx mode
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Reversed duplex mode USING SET MODE When the reversed duplex mode is selected, the receive frequency shifts. (Transmit frequency shifts in normal duplex mode.) Each receive and transmit frequency is shown in the table below with the following conditions; Input frequency : 145.30 MHz Direction : - (negative) Offset frequency : 0.6 MHz Reversed Rx frequency Tx frequency OFF 145.30 MHz 144.70 MHz ON 144.70 MHz 145.30 MHz q Push [SET(LOCK)] to enter set mode. w Push [SET(LOCK)] or [MW(S.MW)] several times until the "REV" display appears as shown below. e Rotate the tuning dial to turn the repeater lockout function to ON or OFF. REPEATER OPERATION 4 z Push [SET B(D-OFF)] to enter set mode. SET x Push [SET B(D-OFF)] or [ENT C(T-OFF)] until B "REV" appears. 4 Push c Push [Y] or [Z] to set the reversed duplex mode ON and OFF. v Push [CLR A(MW)] to exit set mode. Reverse duplex mode is turned ON. r Push [TONE(T-SCAN)] to exit set mode. 22