Icom IC-V8000 Instruction Manual - Page 50
Scan edges programming
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
7 SCAN OPERATION Scan edges programming Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 1A/1b to 3A/3b, in memory channels. q Set the edge frequency of the desired frequency range in VFO mode: ➥ Set the frequency using the tuning dial. ➥ Set other data (e.g. repeater settings, etc.) if desired. w Push [MW(S.MW)] momentarily. • "M" indicator and channel number blink. e Rotate the tuning dial to select one of scan edge channel, 1A, 2A or 3A. r Push [MW(S.MW)] for 1 sec. to program. • 3 beeps sound and VFO is automatically selected. • Scan edge 1b, 2b or 3b is automatically selected when continuing to push [MW(S.MW)] after programming. t To program a frequency for the other pair of scan edges, 1b, 2b or 3b, repeat steps q and r. • If the same frequency is programmed into a pair of scan edges, programmed scan will not function. [EXAMPLE]: Programming 145.300 MHz into scan edges 1A. Rotate for setting frequency, etc. Push MW S.MW momentarily. Rotate ➠ Push MW S.MW for 1 sec. and continue to push " " Beep " Beep " Beep " "Beep 39