Icom IC-V8000 Instruction Manual - Page 53
Scan resume condition
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Scan resume condition USING SET MODE The scan resume condition can be selected as timer or pause scan. The selected resume condition is also used for priority watch. (p. 44) The display shows that the scan will resume 15 sec. after it stops. q Push [SET(LOCK)] to enter set mode. w Push [SET(LOCK)] or [MW(S.MW)] several times until "SCT" or "SCP" appears as shown above. • When "d" is displayed in place of the 100 MHz digit, cancel the DTMF memory encoder in advance. (p. 46) e Rotate the tuning dial to set the desired timer: • "SCT-15" : Scan pauses 15 sec. while receiving a signal. • "SCT-10" : Scan pauses 10 sec. while receiving a signal. • "SCT-5" : Scan pauses 5 sec. while receiving a signal. • "SCP-2" : Scan pauses until the signal disappears and then resumes 2 sec. later. r Push [TONE(T-SCAN)] to exit set mode. SCAN OPERATION 7 z Push [SET B(D-OFF)] to enter set mode. SET x Push [SET B(D-OFF)] or [ENT C(T-OFF)] several B times until "SCT" or "SCP" appears as shown at left. c Push [Y] or [Z] to select the scan resume condi- tion. • See item e at left for scan resume condition details. 7 v Push [CLR A(MW)] to exit set mode. NOTE: Set mode cannot be accessed when memory names are displayed. To set the scan resume condition, return to frequency indication by pushing [MONI(ANM)] on the front panel for 1 sec., or push [FUNC] then [MONI 1(ANM)] (HM133V) to cancel the channel name indication, then set as described on this page. 42