Icom IC-V8000 Instruction Manual - Page 65
Receive accept/receive inhibit, r/code squelch operation during channel indication
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
PAGER/CODE SQUELCH 11 z Push [BANK/OPTION] for 1 sec. to select BANK/OPTION pager mode. • 100 MHz digit shows "P." x Push [SET B(D-OFF)] to enter to the code set mode. • One of either "CP" or "C0" to "C6" blinks. • "C0" is the ID code and "C1" to "C6" are the transmit code. c Push [Y] or [Z] to select the desired code channel. v Enter the desired 3-digit code via the key- pad. b Push [SET B(D-OFF)] to set the channel for "receive inhibit" or "receive accept.". • When "receive inhibit" is set, "SKIP" appears. • Code channel C0 cannot be set as "receive in- hibit." • See right above for "receive accept" and "re- ceive inhibit" details. n Repeat steps c to b to set additional code channels, if desired. m Push [CLR A(MW)] to exit code set mode. • Receive accept/receive inhibit ➥ "Receive accept" ("SKIP" indicator does not appear) ac- cepts pager calls when the transceiver receives a signal with a code the same as that in the code channel. ➥ "Receive inhibit" ("SKIP" indicator appears) rejects calls even when the transceiver receives a code the same as that in the code channel. Transmit codes should therefore be programmed for "receive inhibit," otherwise the transceiver will not reject unnecessary calls. • Pager/code squelch operation during channel indication To use these functions in channel indication, the pager/code squelch setting must be programmed with other memory contents before selecting channel number indication. 11 54