Icom IC-V8000 Instruction Manual - Page 34
Auto repeater
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
4 REPEATER OPERATION Auto repeater USING INITIAL SET MODE (U.S.A. and C.S.A. versions only) The USA and CSA versions automatically activate the repeater settings (DUP- or DUP+ and tone encoder ON/OFF) when the operating frequency falls within the general repeater output frequency range and deactivate them when outside of the range. D Setting the auto repeater function ON/OFF q Push [PWR] to turn power OFF. w While pushing [SET(LOCK)], turn power ON to enter initial set mode. While pushing [SET(LOCK)], turn power ON. e Push [SET(LOCK)] several times until the "RPT" display appears as shown above right. r Rotate the tuning dial to turn the auto repeater function to "R1," "R2" or OFF. Auto repeater function is turned OFF. Auto repeater function is ON, tone encoder is ON. • "R1": auto repeater is ON, tone encoder is OFF. • "R2": auto repeater is ON, tone encoder is ON. t Push [PWR] to exit initial set mode. D Frequency range and offset direction Frequency range Duplex direction 145.200-145.495 MHz 146.610-146.995 MHz "-" appears 147.000-147.395 MHz "+" appears 23