Icom IC-V8000 Instruction Manual - Page 64
Code programming
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
11 PAGER/CODE SQUELCH D Code programming An ID code MUST be programmed into code channel C0. Up to 6 transmit codes are programmable into code channels, C1 to C6, if required. q Push [BANK(OPT)] for 1 sec. • Pager mode is selected. • 100 MHz digit shows "P." Push [BANK(OPT)] for 1 sec. Pager mode indication w Push [SET(LOCK)]. • One of either "CP" or "C0" to "C6" flashes. • "C0" is the ID code and "C1" to "C6" are transmit codes. e Rotate the tuning dial to select code channel C0. • A different ID code must be programmed into each transceiver. y Push [MW(S.MW)] to select 2nd digit, then rotate the tuning dial to set the desired code. • 2nd digit blinks (1st digit stop blinking). • Repeat this step for 3rd digit programming. u Push [MW(S.MW)] to program the ID code. • Long beep sounds and the "C0" indication blinks. i Rotate the tuning dial to select a transmit code channel from "C1" to "C6." o Repeat steps r to u to set transmit code channel. !0 Push [BANK(OPT)] to set the channel for "receive inhibit" or "receive accept." • When "receive inhibit" is set, "SKIP" appears as follows. • Code channel C0 cannot be set as "receive inhibit." • See p. 54 for "receive accept" and "receive inhibit" details. r Push [MW(S.MW)] to set into code programming condition. • The 1st digit blinks and "C0" indication stops blinking. t Rotate the tuning dial to set the desired code. Appears when "receive inhibit" is set to the code channel. !1 Push [TONE(T-SCAN)] to return to the condition in step q. 53