Icom IC-V8000 Instruction Manual - Page 52

7 SCAN OPERATION Skip channel setting USING SET MODE The memory skip function speeds up scanning by checking only those memory channels not set as skip channels. Set skip channels as follows. The display shows that memory channel 1 is set as a skip channel. q Select a memory channel: ➥ Push [M/CALL(PRIO)] to select memory mode. ➥ Rotate the tuning dial to select the desired channel to be a skip channel. w Push [SET(LOCK)] to enter set mode. e Push [SET(LOCK)] or [MW(S.MW)] several times until "CHS" appears as shown above. r Rotate the tuning dial to turn the skip function ON or OFF for the selected channel. • "~" appears : The channel is skipped during scan. (CHS-ON) • "~" disappears : The channel is scanned during scan. (CHS-OFF) t Push [TONE(T-SCAN)] to exit set mode. z Select a memory channel. SET ➥ Select memory mode by pushing [MR/CALL]. B ➥ Push [Y] or [Z] to select the desired channel to be a skip channel. x Push [SET B(D-OFF)] to enter set mode. c Push [SET B(D-OFF)] or [ENT C(T-OFF)] several times until "CHS" appears as shown at left. v Push [Y] or [Z] to set or cancel the skip setting. • See item r at left for skip indicator details. b Push [CLR A(MW)] to exit set mode. NOTES: Even though scan edge channels cannot be set as skip channels, they ARE skipped during memory scan. SET mode cannot be accessed when memory names are displayed. To set the scan resume condition, return to frequency indication by pushing [MONI(ANM)] on the front panel for 1 sec., or push [FUNC] then [MONI 1(ANM)] (HM133V) to cancel the channel name indication, then set as described on this page. 41