Icom IC-V8000 Instruction Manual - Page 56
Dtmf Memory Encoder
View all Icom IC-V8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
9 DTMF MEMORY ENCODER Programming a DTMF code DTMF codes are used for autopatching, controlling other equipment, etc. The transceiver has 10 DTMF memory channels (d0-d9) for storage of often-used DTMF codes of up to 24 digits. z Push [FUNC] then [LOW 6(DTMF)] to turn the DTMF DTMF encoder ON. • "d" appears in place of the 100 MHz digit. x Push [SET B(D-OFF)] to enter the DTMF mem- ory programming condition. c Push [Y] or [Z] to select the desired DTMF memory channel. v Push the desired digit keys. • When the first digit is input, previous memory contents are cleared automatically. • "E" stands for "M" and "F" stands for "# ." • Push [Y]/[Z] and repeat this step if you make a mistake. • The S/RF indicator shows the digit group. The indication increases every 6 digits. b Push [VFO/LOCK] to exit the programming condition. • The [CLR A(MW)] key cannot be used to exit. If pushed, code "A" is input and the previously programmed data is erased. Reprogram in such a case. [EXAMPLE]: Programming "5428AB453" into DTMF memory channel "d4." Push then . Push Push Push Push 45