Intel SPSH4 Product Guide - Page 110
Diskette Drive, Replacing the Diskette Drive
![]() |
UPC - 735858156462
View all Intel SPSH4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Diskette Drive To replace the diskette drive: 1. Turn off power to the server and unplug the AC power cords from the power source. 2. Remove the front access cover (page 67) 3. Remove the fan modules and the foam fan baffle (page 119). 4. Disconnect the power and signal cables from the back of the diskette drive. 5. Remove the screw that secures the diskette drive bracket to the chassis. 6. Remove the bracket and drive assembly from the inside of the front subchassis. C B A A Power cable C Screw B Data cable OM13413 Figure 43. Replacing the Diskette Drive 7. Position the drive and bracket so that the bottom of the bracket is facing up. 8. Holding the front of the drive with one hand, tilt the front of the bracket up to disengage the locating pins on each side of the bracket from the drive. 9. Slide the bracket back and remove it from the drive. ✏ NOTE If you aren't installing a replacement device, install a metal EMI shield on the bay to maintain proper cooling and EMI shielding. 10. Remove the new diskette drive from its protective wrapper and place it on an antistatic surface. 11. Record the drive model and serial numbers in your equipment log. 12. Set any jumpers or switches according to the drive manufacturer instructions. 13. Position the new drive with the component side up and slide the back of the drive under the ears at the back of the bracket (Figure 44). 14. Slide the bracket toward the front of the drive and engage the locating pins on each side of the bracket in the mating holes in the drive frame. 110 Intel SPSH4 Server Platform Product Guide
![](/manual_guide/products/intel-spsh4-product-guide-f2e29ab/110.png)