Intel SR1600UR Service Guide - Page 80
Installing Drive Assemby into the Server System
UPC - 735858206723
View all Intel SR1600UR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
B A AF002944 Figure 51. Removing Retention Device from Drive Carrier 4. Remove the hard drive from its wrapper and place it on an antistatic surface. 5. Set any jumpers and/or switches on the drive according to the drive manufacturer's instructions. 6. With the drive circuit-side down, position the connector end of the drive so that it is facing the rear of the drive carrier. 7. Align the holes in the drive to the holes in the drive carrier and attach it to the carrier with the screws that were attached to the plastic retention device. AF002945 Figure 52. Installing Hard Drive into Carrier 8. With the carrier lever in the open position, slide the drive assembly into the server system and push all the way until it stops (see letter "A" in Figure 53). 9. Close the lever to lock the drive assembly into place (see letter "B" in Figure 53). A B AF002946 Figure 53. Installing Drive Assemby into the Server System 62 Intel® Server System SR1600UR Service Guide