Kenwood TS-890S Operation Manual - Page 122

10 SCAN ● Pressing F5 [SCAN] does not start the scan operation when the memory groups to be scanned are configured as follows. • When the checkboxes for all the memory groups are deselected. • When operating data is not stored in the memory channels of a memory group, even if the checkboxes of the memory group are selected. • When all the memory channels belonging to a memory group are locked out, even if the checkboxes of the memory group are selected. ● Examples on the configuration of All-channel Scan and Group Scan: • When the checkboxes for Memory Groups 1 and 5 are selected, pressing F5 [SCAN] activates Group Scan. In this case, scan is performed on the memory channels included in Memory Groups 1 and 5. • When the checkboxes for all memory groups are selected, pressing F5 [SCAN] activates All-channel Scan. Quick Memory Scan Quick Memory Scan allows the registered quick memory channel to be automatically switched at a specific time interval for scanning. 1 Press [Q-MR>] to call up a quick memory channel. .. Memory Channel Lockout Selected memory channels can be omitted (locked out) in advance before performing Memory Scan. 1 Press F7 [M.LIST] to display the Memory Channel List. 2 Press F2 [ ] or F3 [ ], or turn the [MULTI/CH] control to select a memory channel. 3 Press F6 [L.OUT] to lock out the memory channel. • Lockout is applied to memory channels for which the "Lockout" checkbox is selected. • Pressing F6 [L.OUT] again cancels the lockout mode. • "L.OUT" lights up in the standard mode screen and compression mode screen. 4 Press [ESC] to end the process. 2 Press F5 [SCAN] to start quick memory scan. • Turning the [MULTI/CH] control allows the scan channel to jump rapidly to the next or previous channels. • Pressing F5 [SCAN] again or pressing [ESC] ends Quick Memory Scan. • The scan direction is fixed at the ascending order. Configuring the Conditions for Resuming Scan Scanning stops when signals are received while performing Program Scan (VFO Scan) in the FM mode or during Memory Scan or Quick Memory Scan regardless of the operating mode. • The conditions for resuming the scan operation after it has stopped can be configured. Time-operated (Time-operated mode): Pauses scan for 3 seconds after signals are received. Continues to pause scan for another 3 seconds if signal reception is still in progress after 3 seconds. Scan operation resumes after this interval even if reception is still ongoing. (The maximum duration for pausing scan using the timeoperated mode is 6 seconds.) Carrier-operated (Carrier-operated mode): Pauses scan while signals are received. Scan operation resumes when signals are not received for a duration of 2 seconds. Configure in Menu [4-05] "Scan Resume" Setting Value Time-operated (default)/ Carrier-operated 10-4