Kenwood TS-890S Operation Manual - Page 188

18 TROUBLESHOOTING Troubles Related to Recording and Playback Symptom Probable Cause Corrective Action A message is displayed when [ ] is Timer recording is in progress. pressed during timer recording. To stop timer recording and allow this transceiver to be operated, press and hold F4 [(BREAK)]. To continue with timer recording, press [ ]. A file is created after executing timer The mute function is ON when timer recording Check whether the mute function is ON when recording but the RX audio cannot be is performed. timer recording is performed. RX audio will not heard. be recorded if mute is ON. Voice messages cannot be recorded. The input path for the audio is not correctly configured. Check on the voice message recording standby screen to ensure that the audio input path is correct and the level is not too high or too low. The voice message repeat interval is An attempt has been made to execute repeat Repeat interval functions during playback with not functioning. interval for playing back voice messages only. transmission. It does not function during playback without transmission. Repeat is turned off. Configure repeat to ON for the channel to repeat. RX audio can only be recorded for 30 Full-time recording is enabled. seconds. Full-time recording records only up to 30 seconds regardless of the destination for saving the file. WAV files cannot be played. The format is not supported by this transceiver. The format supported by this transceiver is as follows. No. of channels: 1 (monaural), No. of bits: 16, sampling frequency: 16 kHz The playback volume is very soft. The [AF] control is turned all the way to the left. Turn the [AF] control to the right to adjust the volume. Refer to 14-4 14-4 12-1 12-2 12-3 12-4 4-2 18-8