Kenwood TS-890S Operation Manual - Page 49

BASIC OPERATIONS 4 Configuring Auto Mode Frequency Points Adjustment of Frequencies 1 Display the Auto Mode screen. 2 Turn the Tuning control to select a frequency point. Align the frequency of the selected band with the frequency to register. 3 Press the Mode key or press and hold down the key to switch to the mode to which the band is to be registered. 4 Press F4 [COPY] to copy the frequency and mode. • The frequency and mode of the selected band is imported into the list as a new classification. • To delete a registered classification, press F2 [ ]/ F3 [ ] or turn the [MULTI/CH] control to select the row to delete, followed by pressing F5 [DELETE] to delete the row. Doing so shifts up the classifications after the deleted row in the list. 5 Repeat the steps from 2 to 5 to configure the frequency and mode for all the points. 6 Press F6 [OK]. 7 Press [MENU] or [ESC] to end the process. • When the Auto Mode is turned ON, the mode that is assigned to the respective channels will be automatically selected. In the SSB mode, LSB mode will be selected for frequencies below 10.1 MHz, and USB mode will be selected for frequencies that are 10.1 MHz or higher. • The table below shows an example when auto mode frequency is configured to the HF/50/70 MHz band. Frequency 1.620 MHz 2.000 MHz 3.500 MHz 3.525 MHz 10.100 MHz 10.150 MHz 14.000 MHz 14.070 MHz 14.112 MHz 18.068 MHz 18.110 MHz 21.000 MHz 21.070 MHz 21.125 MHz 21.150 MHz 24.890 MHz 24.930 MHz 28.000 MHz 28.070 MHz 28.150 MHz 28.200 MHz 29.000 MHz 30.000 MHz 50.000 MHz 50.100 MHz 51.000 MHz 52.000 MHz - Mode AM CW LSB CW LSB CW USB CW-R FSK USB CW USB CW FSK-R CW USB CW USB CW FSK CW USB FM-DATA USB CW USB FM USB Preset Frequency Range 30 kHz≦f