Lenovo ThinkCentre M92 Hardware Maintenance Manual (HMM) (May 2012) - ThinkCen - Page 170
Remove the screw that secures the card reader bracket. Then, remove the card reader bracket
View all Lenovo ThinkCentre M92 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Replacing the card reader To replace the card reader, do the following: 1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer. 2. Open the computer cover. See "Opening the computer cover" on page 154. 3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 154. 4. Locate the card reader drive bay. See "Locating internal drives" on page 86. 5. Pivot the optical drive bay upward and disconnect the card reader cable from the USB connector on the system board. See "Locating parts on the system board" on page 83. 6. Remove the screw that secures the card reader bracket. Then, remove the card reader bracket from the chassis. Figure 101. Removing the screw that secures the card reader 7. Remove the two screws that secure the card reader to its bracket. Then remove the failing card reader from the bracket. 8. Install a new card reader into the bracket and install the two screws to secure the card reader to the bracket. 164 ThinkCentre Hardware Maintenance Manual