Lexmark X658DFE Service Manual - Page 111

7462 Error code or message 28x.70 x = bin number Error contents Stapler mechanism not in home position failure Applies to: StapleSmart finisher 28x.71 x = bin number Diverter gate transition to standard bin not detected Applies to: StapleSmart finisher 281.72 x = bin number Sensor (media in stapler) static jam Applies to: StapleSmart finisher 290.00 290.01 290.02 Sensor (ADF sheet through) static jam Sensor (ADF sheet through) late jam Sensor (ADF 1st scan) late jam Description/Action Possible repair actions The sensor (home signal) within the stapler assembly detected that the stapler mechanism was not in the home position before stapling. The sensor (diverter gate HP) does not detect transition of the diverter gate to the standard bin. Media remains on the sensor (media in stapler) during the warm up sequence. Media remains on the sensor (ADF sheet through) during the warm up sequence. The media does not reach the sensor (ADF sheet through) within the specified time. The media does not reach the sensor (ADF 1st scan) within the specified time. 1. Check all the connections on the controller card and the stapler assembly. 2. Remove the staple cartridge and remove all jammed staples. If the cartridge is jammed and can not be removed, go to step 3. 3. Remove the stapler assembly. Go to "Stapler finisher stapler unit assembly removal" on page 4-196. 4. Manually rotate the drive gears and reset the stapler and remove all jammed staples then reinstall the stapler assembly. 5. If problem remains, replace the stapler assembly. Go to "Stapler finisher stapler unit assembly removal" on page 4-196. 1. Check all the connections on the output option controller card. 2. Check the sensor (diverter HP) for damage and replace if needed. Go to "Stapler finisher sensor (diverter HP) removal" on page 4-198. 3. Replace the output option if problem remains. 1. Inspect the sensor (media in stapler) for proper installation and reinstall if needed. 2. Replace the sensor (media in stapler) Go to "Stapler finisher sensor (media in stapler) removal" on page 4-198. See "Sensor (ADF sheet through) static jam service check" on page 2-119. See "Sensor (ADF sheet through) late jam service check 290.01" on page 2-120. See "Sensor (ADF 1st scan) late jam service check" on page 2-121. Diagnostic information 2-77