Lexmark X658DFE Service Manual - Page 260

7462 Min Copy Memory 1. Touch to select Min Copy Memory from the Configuration Menu. The panel displays the setting's name in the header and [setting's current value] below the header row. 2. Touch or to change the setting. For example, the values may be 25 MB, 35 MB, 50 MB, and 100 MB. The default is 25 MB. Values will only be displayed if the amount of installed DRAM is at least twice the amount of the value, that is, at least 200 MB of installed DRAM is required to display the 100 MB selection. 3. Touch Submit to save your change. Touch Back to exit without changing the value. NumPad Job Assist 1. Touch to select NumPad Job Assist from the Configuration Menu. The panel displays the setting's name in the header and [setting's current value] row. 2. Touch or to change the setting. The settings are On and OFF. 3. Touch Submit to save your change. Touch Back to exit without changing the value. below the header Format Fax Storage This setting enables you to format the non-volatile storage used for storing faxes. To change this setting, touch to select Format Fax Storage from the Configuration Menu. Formatting Fax Flash DO NOT POWER OFF appears on the LCD while the format operation is active. Note: If an advanced password has been established, you must enter this password in order to change the setting. Fax Storage Location To change this setting, touch to select Fax Storage Location from the Configuration Menu. 1. Touch or to change the setting. The settings are Disk and NAND. 2. Touch Submit to save your change. Touch Back to exit without changing the value. ADF Edge Erase The ADF Edge Erase and FB Edge Erase settings specify, in millimeters, the size of a border around the scanned image that will be erased. For copies, the printed page will have a 2 mm no-print border. The larger of the 2 mm no-print border and the Edge Erase setting will be used in this situation. To change this setting: 1. Touch to select ADF Edge Erase from the Configuration Menu. The panel displays the setting's name in the header and [setting's current value] row. 2. Touch to increase the value or to decrease the value. The values are 0 through 6. The default is 3. below the header 3-34 Service Manual