Lexmark X658DFE Service Manual - Page 246

7462 OUTPUT BIN TESTS Feed Tests (output bins) Use these tests to verify that media can be fed to the standard output bin. No information is printed on the media fed to the output bin, because the printhead is not engaged during this test. These tests can use any media size or envelope supported by the printer. To run the Feed Tests for the output bins: 1. Touch to select Feed Tests from the OUTPUT BIN TESTS. 2. Touch to select the output bin you want the paper to exit into. 3. Touch to select either Single or Continuous. • Single-feeds one sheet of media from the selected source. • Continuous-media continues feeding from the selected source until Stop is pressed. Touch Back to return to OUTPUT BIN TESTS. Sensor Test (standard output bin) This test is used to verify if the standard bin sensor is working correctly. To run the Sensor Test for the standard bin: 1. Touch to select Sensor Test from OUTPUT BIN TESTS. 2. Touch to select Standard Bin from Sensor Tests. 3. Manually actuate the bin sensor by moving the flag in and out of the sensor, and the display changes. The following screen is displayed: Bin Empty: empty or Bin Empty: full. 4. Press Stop to exit the test. BASE SENSOR TEST This test is used to determine if the sensors located inside the printer are working correctly. To run the Base Sensor Test: 1. Select BASE SENSOR TEST from the DIAGNOSTICS menu. The following sensors are listed: • Toner Level-Toner level sensor (remove the cartridge and replace to actuate the sensor) • Input-Input sensor • Output-Output (exit) sensor • NarrowMedia-Output (exit) sensor • Front Door-Front door sensor 2. Manually actuate the sensors to verify that each sensor switches from Open to Closed. 3. Press Stop to exit the test. 3-20 Service Manual