Lexmark X658DFE Service Manual - Page 166

7462 4 Place an undamaged document in the ADF, and perform a ADF test. Does the error remain? 5 Perform a print test using the ADF. Does the problem remain? Sensor (ADF media exit) late jam service check Replace the ADF controller card assembly. Go to "ADF controller card removal (models X651, X652, X654, X656, and X658)" on page 4-65. Go to step 5. Contact next highest level of tech support. Problem solved. Problem solved. Use this procedure for the following jams: • 294.01 Step Check Yes 1 Check the original document condition. Go to step 2. Is the original document free of paper clips and staples as well as damage such as creases, tears, holes or excessive wear? 2 Check the ADF rolls for wear. Go to step 3. Is the ADF feed/pick roll assembly or the ADF separation roll guide assembly free of excess wear? 3 Check the media path for contaminates. Is the media path free of excess media dust and foreign objects such as paper clips and staples? Go to step 4. No Remove damaged original document and replace with a new undamaged original document. Perform a ADF test. If the problem remains, go to step 2. Clean or replace the ADF feed/pick roll assembly or the ADF separation roll assembly. Go to "ADF feed / pick roll assembly removal (models X651, X652, X654, X656, and X658)" on page 4-59 or "ADF separator torque limiter assembly removal (models X651, X652, X654, X656, and X658)" on page 4-61. Remove all contaminates from the media path. 2-132 Service Manual