Onkyo TX NR807 Owner Manual - Page 116
Connecting Zone 2, Connecting Your Zone 2 Speakers Directly, to the AV receiver, Amp in Zone 2
UPC - 751398008788
View all Onkyo TX NR807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
Multi Zone-Continued In addition to your main listening room, you can also enjoy playback in the other room, or as we call Multi Zone. And, you can select a different source for each room. Connecting Zone 2 There are two ways you can connect Zone 2 speakers: 1. Connect them directly to the AV receiver. 2. Connect them to an amp in Zone 2. Connecting Your Zone 2 Speakers Directly to the AV receiver This setup allows 5.1-channel playback in your main room and 2-channel stereo playback in Zone 2, with a different source in each room. This is called Powered Zone 2, as the Zone 2 speakers are powered by the AV receiver. Note that when Powered Zone 2 is turned off, you can enjoy 7.1-channel playback in your main room. To use this setup, you must set the "Powered Zone2" setting to "Act" (see page 118). Connecting Your Zone 2 Speakers to an Amp in Zone 2 This setup allows 7.1-channel playback in your main listening room and 2-channel stereo playback in Zone 2, with a different source in each room. Hookup • Use an RCA audio cable to connect the AV receiver's ZONE 2 PRE OUT L/R jacks to an analog audio input on your Zone 2 amp. • Connect your Zone 2 speakers to the speaker terminals on your Zone 2 amp. Main room TV Hookup • Connect your Zone 2 speakers to the AV receiver's SURR BACK/ZONE 2 L/R speaker terminals. Main room AV receiver TV AV receiver Zone 2 R Zone 2 IN R L Receiver/ integrated amp Note: With the default settings, the Zone 2 volume must be set on the Zone 2 amp. If your Zone 2 amp has no volume control, set the "Zone2 Out" setting to "Variable" so that L you can set the Zone 2 volume on the AV receiver (see page 119). Notes: • With this setup, the Zone 2 volume is controlled by the AV receiver. • Powered Zone2 cannot be used if "Speaker Type (Front)" is set to "Bi-Amp" (see page 51). Zone 2 12V Trigger (TX-NR807) When Zone 2 is turned on, the output from the 12V TRIGGER OUT ZONE 2 goes high (+12 volts, 150 milliamperes max). Connecting this jack to a 12-volt trigger input on a component in Zone 2 will make that component turn on or off as and when Zone 2 is turned on or off on the AV receiver. 116