Onkyo TX NR807 Owner Manual - Page 51
Speaker Settings, Powered Zone 2/3
UPC - 751398008788
View all Onkyo TX NR807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
First Time Setup-Continued Speaker Settings If you change these settings, you must run Audyssey MultEQ® Room Correction and Speaker Setup again (see page 54). If the impedance of any speaker is 4 ohms or more but less than 6, set the minimum speaker impedance to 4 ohms. If you've connected your front speakers to the FRONT L/R and SURR BACK/ZONE 2 L/R terminal posts for bi-amping, you must change the "Speakers Type(Front)" setting. For hookup information, see "Bi-amping the Front Speakers" on page 21. Notes: • When bi-amping is used, the AV receiver is able to drive up to 5.1 speakers in the main room. • Before you change these settings, turn down the volume. 1 Press the [RECEIVER] button, followed by the [SETUP] button. The main menu appears onscreen. If the main menu doesn't appear, make sure the appropriate external input is selected on your TV. 2 Use the Up and Down [R]/[X] but- tons to select "2. Speaker Setup", and then press [ENTER]. The "Speaker Setup" menu appears. 2. Speaker Setup 1. Speaker Settings 2. Speaker Configuration 3. Speaker Distance 4. Level Calibration 5. Equalizer Settings 6. THX Audio Setup 3 Use the Up and Down [R]/[X] but- tons to select "1. Speaker Set- tings", and then press [ENTER]. The "Speaker Settings" menu appears. 2-1. Speaker Settings Speaker Impedance Speakers Type(Front) Powered Zone2 Powered Zone3 6ohms Normal Not Act Not Act 4 Use the Up and Down [R]/[X] but- tons to select "Speaker Imped- ance", and then use the Left and Right [F]/[S] buttons to select: 4ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6. 6ohms: Select if the impedances of all speakers are between 6 and 16 ohms. 5 Use the Up and Down [R]/[X] but- tons to select "Speakers Type(Front)", and then use the Left and Right [F]/[S] buttons to select: Normal: Select this if you've connected your front speakers normally. Bi-Amp: Select this if you've connected your front speakers for bi-amped operation. Note: Powered Zone2/3 cannot be used if "Speakers Type(Front)" is set to "Bi-Amp". 6 Press the [SETUP] button. The setup menu closes. Powered Zone 2/3 See "Setting the Powered Zone 2/3" on page 118. Note: This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 51