Onkyo TX NR807 Owner Manual - Page 14

Remote Controller Installing the Batteries 1 To open the battery compartment, press the small lever and remove the cover. Aiming the Remote Controller To use the remote controller, point it at the AV receiver's remote control sensor, as shown below. Transmission Remote control sensor AV receiver 2 Insert the two supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment. 3 Replace the cover and push it shut. 30° off center Approx. 16 ft. (5 m) (Left/Right/Up/Down) Received Transmitter Incoming sensor 15 AV receiver 15 15° off center Approx. 16 ft. (5 m) (Left/Right/Up/Down) Notes: • If the remote controller doesn't work reliably, try replacing the batteries. • Don't mix new and old batteries or different types of batteries. • If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion. • Expired batteries should be removed as soon as possible to prevent damage from leakage or corrosion. 14 Notes: • The remote controller may not work reliably if the AV receiver is subjected to bright light, such as direct sun- light or inverter-type fluorescent lights. Keep this in mind when installing. • If another remote controller of the same type is used in the same room, or the AV receiver is installed close to equipment that uses infrared rays, the remote control- ler may not work reliably. • Don't put anything, such as a book, on the remote con- troller, because the buttons may be pressed inadvert- ently, thereby draining the batteries. • The remote controller may not work reliably if the AV receiver is installed in a rack behind colored glass doors. Keep this in mind when installing. • The remote controller will not work if there's an obstacle between it and the AV receiver's remote con- trol sensor. • When the remote control codes have been registered and you want to operate another component (page 125), or when you want to operate an Onkyo component without V connection, point the remote controller at the other component to use it. • When you want to operate an Onkyo component with V connection or an -compatible compo- nent connected via HDMI (pages 127, 128), point the remote controller at the AV receiver's remote control sensor.