Onkyo TX NR807 Owner Manual - Page 121
Adjusting the Volume for Zones, Muting Zones, Adjusting the Tone and Balance of Zones
UPC - 751398008788
View all Onkyo TX NR807 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Multi Zone-Continued Notes: • Only analog input sources are output by the ZONE 2/ 3 PRE OUT and ZONE 2/3 L/R speaker terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it's connected to an analog input. • You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that station will also be used in Zone 2. • When you connect Zone 2 speakers directly to the AV receiver, listening modes that require surround back speakers or front high speakers or front wide speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES, THX Select2 Cinema, Dolby Pro Logic IIz height, and Audyssey Dynamic Surround Expansion™ are unavailable. • When you connect Zone 3 speakers directly to the AV receiver, listening modes that require surround speakers are unavailable. • When the input selector of Zone 2/3 is selected, power consumption on standby mode slightly increases. • While Zone 2/3 is on, V functions will not work. Adjusting the Volume for Zones Remote controller On the remote controller, press the [ZONE] button repeatedly, and then use the VOL [R]/[X] button. AV receiver On the AV receiver, press the [ZONE 2] or [ZONE 3] button (the ZONE 2/3 indicator and Zone 2/3 selector on the display flashes) and press [LEVEL] button followed by the [F]/[S] buttons within 8 seconds. Muting Zones Remote controller On the remote controller, press the [ZONE] button repeatedly, and then press the [MUTING] button. To unmute a zone, on the remote controller, press the [ZONE] button, and then press the [MUTING] button again. Adjusting the Tone and Balance of Zones 1 AV receiver On the AV receiver, press the [ZONE 2] or [ZONE 3] button. 2 Press the AV receiver's [TONE] button repeatedly to select "Bass", "Treble" or "Balance". 3 Use the Right [S] and Left [F] buttons to adjust the bass, treble or balance. • You can boost or cut the bass or tre- ble from -10 dB to +10 dB in 2 dB steps. • You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps. Notes: • Zones can also be unmuted by adjusting the volume. • The Zone 2 volume, tone, and balance function have no effect on the ZONE 2 PRE OUT when the "Zone2 Out" setting is set to "Fixed" (page 119). • The Zone 3 volume, and balance function have no effect on the ZONE 3 PRE OUT when the "Zone3 Out" setting is set to "Fixed" (page 119). • Even if you repeatedly press the remote controller's [ZONE] button to select zones, the last zone selection will be retained once you have switched to other components by pressing other REMOTE MODE buttons after pressing the [ZONE] button. 121